User Information - Eaton BLK Super LED Technical Manual

BLK Super LED Technical Manual
Technical Data
Casing
Hood
Insulation class
Protection type
Cable gland
Temperature range
Operation (Ta)
Storage
Operating position
Operating conditions
Terminals
Weight
Operating modes:
Pos. 0
Pos. 1
Pos. 2

User information

1. The appliance has been designed for insulation class I and is only to be connected to, and operated with, the
specified voltage. Specifications of polarity must be observed. Ensure that the ground wire is correctly connected.
2. Ensure that the casing is not damaged.
3. The relevant codes of Practice an Trade Association requirements for save operation must be observed.
4. Live components may be come exposed when covers are opened or parts are removed. Before opening the
appliance for alignment, maintenance, repair or replacement of parts, the appliance must be disconnected from all
power supplies. If it is necessary to carry out alignment, maintenance or repair on the open and live device, this is
only to be undertaken by a qualified specialist who has received corresponding instruction.
5. Capacitors may still be in a charged state even after the appliance has been disconnected from all power supplies.
6. The appliance is only to be operated under the specified ambient conditions and in the specified mode of operation.
Unfavourable ambient conditions may cause damage to the appliance and put the user's life at risk. Unfavourable
ambient conditions may be:
excessive air humidity (> 95%, relative, condensing)
•
moisture, dust (observe protection class)
•
flammable gases, vapours, solvents
•
excessively high ambient temperatures (>+70°C)
•
7 . The pressure compensating valve fitted on the base of the casing must not be covered.
8. The ambient temperatures must be within the specified range.
9. The appliance is designed for both indoor and outdoor use.
10. The installation and commissioning of the appliance may only be carried out by a qualified specialist; the same
applies to any repairs with original spare parts. The use of other than original spare parts may cause damage or injury.
11. The appliance has a very intense lighting strength. In order to avoid damage to eyesight, please refrain from looking
at the lamp for any length of time when it is in operation.
Subject to alterations or errors
6 BLK SUPER LED TECHNICAL MANUAL
Seawater-resistant aluminium (ABS), Surface: epoxy resin-coated, colour: grey / black
Polycarbonate; Colours: glass-clear, red, yellow, green, blue
I
IP 65
1x M20 x 1.5 for cables 8-12 mm
see table on page 2
-60°C to +80°C
any, preferably wall mounted (cable entry downward) / ceiling mounted
indoor or outdoor
terminal capacity: max. 2.5 mm
2
approx. 1.4 kg
Continuously on
Flashing 0.5 s on, 0.5 s off
Strobe sequence 7x each: 55 ms on, 19 ms off, 1s pause, then sequence repeats
TMF0071.A www.eaton.com