General Information; Important Information; Safety; Power Supply - nilan Compact P2 Installation Instructions Manual

General information

Important information

WARNING
Do not turn on the power supply for the unit until there is water in the hot water tank and the outdoor unit has been con-
nected up to the unit.
If, during the construction phase, you want to have access to ventilation and domestic hot water, but you do not want to
connect up the outdoor unit, you must uninstall the circulation pump between the indoor and the outdoor units.

Safety

Power supply

CAUTION
Always disconnect the power supply to the unit if an error occurs that cannot be rectified via the control panel.
CAUTION
If an error occurs on electrically conductive parts of the unit, alway contact an authorised electrician to rectify the error.
CAUTION
Always disconnect the power to supply to the unit before opening the unit doors, for instance for installation, inspection,
cleaning and filter change.

Heat pump domestic hot water

CAUTION
Avoid direct contact with the heating system pipes in the heat pump as they can get very hot.
CAUTION
To protect the heat pump against damage, it is equipped with electronic temperature monitoring.
The heat pump must undergo suitable service inspections under applicable legislation and regulations to keep it in good condition and
in compliance with safety and environmental requirements.
Responsibility for maintenance of the heat pump rests with the owner/user.

Heat pump for central heating

CAUTION
To secure the heat pump against damages, it is fitted with the following safety equipment:
• Expansion systems for central heating and buffertank
• Safety valve for central heating and buffertank
• Low and high pressure switch for compressor
The heat pump must undergo suitable service inspections under applicable legislation and regulations to keep it in good condition and
in compliance with safety and environmental requirements.
Responsibility for maintenance of the heat pump rests with the owner/user.
4