Motorola APX 900 2 Manual page 13

Preparing Your Radio for Use
Attaching/Removing the Accessory Connector Cover
The accessory connector is located on the antenna side of the radio. It is used to connect accessories to the
radio.
Note: To prevent damage to the connector, shield it with the connector cover when not in use.
Insert the hooked end of the cover into the slot above the connector.
Press downward on the cover's top to seat it in the slot.
Once in place, tighten by rotating the thumbscrew clockwise by hand.
To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it disengages from
the radio.
If the thumbscrew is too tight, use an Allen wrench to loosen it first.
Rotate and lift the connector cover to disengage it from the radio.
13
CONTENTS < PREV NEXT >