Installing The Chassis In A Four-Post Rack - Cisco Nexus 93360YC-FX2 Hardware Installation Manual

Installing the Chassis
What to do next
You are ready to mount the chassis to the four-post rack.

Installing the Chassis in a Four-Post Rack

You need to slide the chassis onto the bottom-support rails so that the power supply end locks onto the chassis
stops at the end of the rails and so that the front-mount brackets on the chassis come into contact with the
front-mount rails on the rack.
Warning
Warning
Before you begin
• Make sure that the four-post rack is properly installed and secured to the concrete subfloor.
• Make sure that the bottom-support rails are installed so that the fan modules will be in the appropriate
• Make sure that two front-mount brackets are securely fastened to the sides of the chassis at the port end.
• Make sure that you have two customer-supplied rack-mount screws (M6 x 10 mm or appropriate screw
Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Statement 1032 Lifting the Chassis
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles
on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the
weight of the unit.
aisle as follows:
• Burgundy (port-side intake airflow) fan modules are positioned in a hot aisle (the chassis stop on
the bottom-support rails is positioned by the hot aisle).
• Blue colored (port-side exhaust airflow) fan modules are positioned in a cold aisle (the chassis stop
on the bottom-support rails is positioned by the cold aisle).
for the vertical mounting rails on the rack).
Cisco Nexus 93360YC-FX2 ACI-Mode Switch Hardware Installation Guide
Installing the Chassis in a Four-Post Rack
21