Therefore, the utilization of the unit other than those indicated in these instructions is not recommended. Please contact your local agent, as the occasion arises. HITACHI's liability shall not cover defects arising from the alteration performed by a customer without HITACHI's consent in a written form.
Page 8
Children should be supervised that they do not play with the appliance. The appliance should not be installed in the laundry. Table 2.1 Line-up of Indoor Unit 10.0 Capacity (HP) RPI-8.0FSNQH#V2/H RPI-10.0FSNQH#V2/H Model...
Page 10
Regarding the instructions of Wired Remote Control Switch or Wireless Remote Control Switch,read the operation manual attached to the control switch.
Page 17
Flaring Dimension (Only for R410A or R407C) Perform the flaring work as shown below. Diameter -0.4 R410A R407C 6.35 13.0 9.53 13.5 16.2 12.7 16.5 15.88 19.5 19.4 23.3 19.05 (*)It is impossible to perform the flaring work with 1/2H material. In this case, use an accessory pipe(with a flare).
Page 21
Maximum Current EN60 335 -1 EN60 335 -1 Capacity 4.0mm 0.75mm 10.0 The wire sizes marked with *1 in the above table are selected at the maximum current of the unit according to the European Standard, EN60335-1.Use the wires which are not lighter than the ordinary polyvinyl chloride sheathed flexible cord (code designation H05VV-F).
Page 22
Ex.) Set at No.5 Cycle Set by inserting Setting DSW5 Slotted screwdriver Position into the groove Set All Pins OFF Before shipment. DSW5 and RSW2 are set to "0". RSW2 Max.64 cycles are available to set when all the equipment to be connected are corresponding to H-LINK.
Page 23
1055895 Qingdao Hisense Hitachi Air-conditioning Systems Co., Ltd. Add: 218, Qianwangang Road, Economic & Technical Development Zone, Qingdao, P.R. China P00825Q, 2018.04...