Kimball Office Xsite Systems Assembly Instructions

Xsite ®
Attach Privacy Panel to Xsite
Tools Required
■ Level
Package Contents
■ Caster
Clamp Plate
■
Base Pivot Bracket
■
with Carpet Gripper
Installation
Note: On Xsite panels, the privacy panel attachment bracket can be
installed at the 5-high position only. (Figure A).
1. Tilt clamp plate slightly and insert the plate into the
Xsite Traxx channel at the desired position.
Note: Privacy panel can be installed at any location along
an Xsite Traxx. (Figure B).
2. Position the attachment bracket over the clamp plate and
use the screws provided to connect the attachment bracket
to the plate. Tighten screws securely when attachment
bracket is in desired position. (Figure C).
3. Insert base pivot bracket and caster into openings in
bottom of the posts on privacy panel. Make sure bracket
and caster fully seat. (Figure D).
Figure A
Xsite
panel
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2015812 Revision A-06
■ Phillips Screwdriver
■ Double-sided Adhesive Tape
Attachment Bracket
■
2 10-24 x 1 ⁄ " Flathead
■
2
Machine Screws
Attachment bracket
can be installed at
5-high position only
Systems Assembly Instructions
Figure B
Figure C
Use screws to connect
attachment bracket to
clamp plate
Figure D
Insert base
pivot bracket
Page 1 of 2
Insert into
Traxx channel
Clamp Plate
Insert caster