Subscribe to Our Youtube Channel
Related Manuals for Crosswater MPRO SENSE US-US-PRO6005CW
Summary of Contents for Crosswater MPRO SENSE US-US-PRO6005CW
- Page 1 US-PRO2005CW MPRO SENSE Touchless Two-piece toilet with motion sensor automated flush Finished Wall 28-1/2" 14-3/4" 11" Finished Floor 12"~11" US-PRO6005CW US-PRO8005CW 1 - 8...
-
Page 2: Installation Instruction
Installation Instruction PARTS SUPPLIED: Check to make sure that all these parts are included in the package: Sensor module Flush Button & holder Tank fitting parts Nut - qty. 2 qty. 1 qty. 1 Clip - qty. 2 Bolt - qty. 2 qty. - Page 3 Figure 1 1) Clean any debris out of the closet flange (not supplied) then install the mounting bolts into the slot of the flange head down with the threaded shank of the bolt pointed upward as shown (see Figure 1). Slide each bolt until the end of slot.
-
Page 4: Usage Instruction
After Installation/Adjustment Figure 5 Flush the toilet two to three times to confirm there is no water leakage and that the lever mechanism is working properly. 6) Connect the opposite end of the water supply hose to the angle stop ( ee igure 5). A flexible supply hose is recommended. - Page 5 Valve Installation Instruction Replacement Installation Please read the instruction carefully to avoid damage to the valve and to ensure correct installation. Turn off water supply and flush the toilet. Remove the tank lid and place it upside down on a clean surface. Record the orientation of the flush valve for reassembly.
-
Page 6: Push Button Installation
Water inlet hose installation hose connector water inlet joint rubber washer hose plastic washer 1) Take off the fixing nut, washers from the hose connector. 2) Connect hose to the flush valve. Insert hose connector end to the inlet hole of cistern. Water supply pipe 3) Fix the hose by rubber washer, plastic washer and fixing nut. - Page 7 Sensor module and sensor Installation 2) Put 3pcs AAA batteries (not supplied) into the sensor and tighten the screws. Attention: this step has to be finished within 3 minutes 1) Put 4pcs AA batteries (not supplied) into the after step 1 so the code match will be automatically done. sensor module and tighten the screws.
-
Page 8: Care And Maintenance
Warranty - Chinaware - Limited lifetime. Commercial: 1 year. Mechanical parts: 5 years, Commercial: 1 year. Seat : 1 year, Commercial: 1 year. For further information contact: Crosswater London, 393 Fortune Blvd., Milford, MA 01757 www.crosswaterlondon.com Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068 email: technical@crosswaterlondon.com...
Need help?
Do you have a question about the MPRO SENSE US-US-PRO6005CW and is the answer not in the manual?
Questions and answers