Subscribe to Our Youtube Channel
Related Manuals for Crosswater M-PRO US-PRO9005CW
Summary of Contents for Crosswater M-PRO US-PRO9005CW
- Page 1 M-PRO One-piece Dual-flush Toilet US-PRO9005 Finished Wall 28" 14-1/2" 1/2" 1" 1.28fpg/4.8lpf 1" 1-1/2" 11" 12"~11" Finished Floor US-PRO9005 1 - 6...
- Page 2 Installation Instructions PARTS SUPPLIED: Check to make sure all these parts are included in the package: Clip - qty. 2 Bolt - qty. 2 Nut - qty. 2 Protector sleeve Screw - qty. 2 Washer - qty. 2 Cap - qty. 2 qty.
- Page 3 Figure 1 1) Clean any debris out of the closet flange (not supplied), then install the mounting bolts into the slot of the flange head down with the threaded shank of the bolt pointed upward as shown (See figure 1). Slide each bolt until the end of slot.
- Page 4 Adjusting the Push Button Rods tank lid After making sure the push buttons are installed correctly, incorrect - place the lid on the tank. rods pressing down or touching valve If rod(s) is too long, water will keep running in the toilet. 1) Loosen the lock nut(s) counterclockwise.
- Page 5 Fill Valve Installation Instruction Figure 2 Replacement Installation Figure 3 Figure 1 REFI LL TU BE REFI LL TU BE 1) Shut off the water supply. Flush the toilet and remove any remaining water from the tank. Remove the old fill valve. FLO AT 2) Install new fill valve by sliding the threaded FLO AT...
- Page 6 Do not use in-tank cleaners as they can seriously damage the fittings in the tank. This damage could cause leakage and result in property damage. Crosswater London shall not be responsible or liable for any damage that occurs as a result of the use of in-tank cleaners.
Need help?
Do you have a question about the M-PRO US-PRO9005CW and is the answer not in the manual?
Questions and answers