Install Microinverter - Zendure SolarFlow ZDSPVH1200 User Manual

EN
5.3.4 Install Smart PVHub
Note:
• Please install the PVHub in a place out of direct sunlight
• The length of our solar cables are 3 meter, so before confirming the
location of the PVHub's installation, please measure the distance from
MC4 connector of solar panel to MC4 connector of PVHub
1
3
1
2
4
Mark Location, Find a wall you plan to install, one person fixes the
1
Smart PVHub on the wall with his hands, and the other person marks
the positions of the four screw holes of the PVHub with a marker.
Drilling,drill four diameter 8mm mounting holes at the four marked
2
positions.
Installing screws,first Respectively Install the yellow plastic expansion
3
screw tube into the 4 holes which step 3 drilling,then screw 2/3 of the
& screws into the yellow plastic expansion tube.
1 2
Hang Smart PVHub, please hang the Smart PVHub on exposed part of
4
the screw
1
One person fixes the Smart PVHub with both hands, and the other one
5
screws the rest of
Install another two screws, screw 3 and 4 into the yellow plastic
6
expansion tube and completely into the wall.In this way, you have
completed the installation of PVHub.

5.3.5 Install Microinverter

Note: The method of assembly is subject to the instructions of the
microinverter.
• In order to less connections, it is recommended that micro-inverter is
installed between Smart PVHub and home socket, close to the PVHub.
• Ensure a distance of at least 50mm between the Smart PV Hub and the
microinverter to dissipate heat.
10
2
1
4
3
3
& .
2
& screw into the wall completely.
1 2
2
4
2
1
4
3
5
2
2
1
1
1
1 4
4
3
3
3
1
4
6
2
2