Table of Contents
Advertisement
RHW-44 WOODBURNING FIREPLACE
A. LISTINGS AND CODE APPROVALS
The RHW-44 fireplace system has been tested and
listed in accordance with UL 127 and ULC S610
Standards, and has been listed by Underwriters
Laboratories Inc. for installation and operation in the
United States and Canada as described in these
Installation & Operating Instructions.
The model RHW-44 fireplace has been tested and
listed for use with the components listed below. The
optional components may be purchased separately
and installed at a later date. However, installation of
THIS HEAT-N-GLO FIREPLACE AND ITS COMPONENTS ARE DESIGNED TO BE
INSTALLED AND OPERATED AS A SYSTEM. ANY ALTERATION TO OR
SUBSTITUTION FOR ITEMS IN THIS SYSTEM, UNLESS ALLOWED BY THESE
INSTALLATION INSTRUCTIONS, WILL VOID THE UNDERWRITERS LABORATORIES
LISTING AND MAY VOID THE PRODUCT WARRANTY. IT MAY ALSO CREATE A
HAZARDOUS INSTALLATION. READ THROUGH THESE INSTRUCTIONS
THOROUGHLY BEFORE STARTING YOUR INSTALLATION AND FOLLOW THEM
B. DESCRIPTION OF THE FIREPLACE SYSTEM
This Heat-N-Glo fireplace system consists of the following:
1.
Fireplace/Integral Grate
2.
Chimney Termination Cap
Optional components include:
1.
Glass Doors
2.
Outside Combustion Air System
NOTE: Illustrations throughout these
instructions reflect "typical installations"
and are for design purposes only. Actual
installation may vary slightly due to indi-
vidual design preferences. However,
minimum and maximum clearances must
be maintained at all times.
The illustrations and diagrams used
throughout these installation instructions
are not drawn to scale.
3-00
WARNING!
CAREFULLY THROUGHOUT YOUR PROJECT.
an outside air kit will require significant reconstruc-
tion, and should be installed at the time of the initial
fireplace installation.
Check with your Local Building Code Agency prior to
installing this fireplace to ensure compliance with local
Codes, including the need for Permits and follow up
inspections. If any assistance is required during
installation, please contact your local dealer or the
Heat-N-Glo Technical Services Department,
20802 Kensington Blvd., Lakeville, MN 55044.
3.
Chimney System
4.
Hearth Extension
Tools and Building Supplies Normally
Required
Tools:
Building Supplies:
Saw
Hearth Extension Material
Pliers
Wall-finishing Materials
Hammer
Framing Material
Phillips Screwdriver
Fireplace Surround
Tape Measure
Caulking Material
Plumb Line
Level
Electric Drill and Bits
Framing Square
3
33147A
Advertisement
Table of Contents
