Table of Contents
Advertisement
INDEX
Lubrication
WARNING
Do Not lubricate machine while machine is in
motion. If any guards are removed for lubricating,
they must be replaced before operating.
WARNING
All hydraulically or mechanically elevated
components must be blocked to prevent
accidental lowering or must be lowered to the
ground when adjustments or repairs are made.
WARNING
Before working on this machine, disengage
tractor PTO, shut off tractor and allow all moving
parts to come to a complete stop.
WARNING
Replace all shields and guards after servicing
and before starting machine. Always keep all
safety shields in place when operating machine.
GREASE EVERY
25-50 HOURS
TABLE OF CONTENTS
1. Proper lubrication of your machine is instrumental in
obtaining optimum performance and extended life.
Neglect leads to needless breakdowns and
unnecessary expenses.
2. Check oil level at the check plug on the chain housing
when the Power Ditcher is in an upright position. Oil
should be level with the plug hole. The chain housing
was filled to the proper level at the factory with one
quart of SAE 90 oil or equivalent. A similar grade
should be used for replacement.
3. Lubricate the Drive Shaft with a good grade of Lithium
Soap Base Grease every 25 to 50 hours of operation
See Figure 4-3.
shaft and pack tube with a generous amount of
grease. The drive shaft has four grease fittings.
41-3/8" FULLY EXTENDED
28-1/2" FULLY RETRACTED
Figure 4-3: Drive Shaft Lubrication
OPERATION AND MAINTENANCE
Remove the male end of the drive
GREASE EVERY
25-50 HOURS
4-5
Advertisement
Table of Contents
