Installation Instructions - AEG COMFORT 6000 User Manual

5. INSTALLATION INSTRUCTIONS

5.1 Exhausting hot air
In the Cool Mode, the unit must be placed
close to a window or opening so that the
warm exhaust air can be ducted outside.
First position unit on a flat floor and make
sure there's a minimum of 50cm clearance
around the unit, and that it is close to a
power socket.
1. Extend either side of the hose (Fig. 1)
and screw the hose to adaptor A (Fig. 2).
2
A
1
2. Extend the other side of the hose and
screw it to adaptor B (Fig. 3).
3. Lock the adaptor A into the unit. (Fig. 4)
Lock
Extend the side of hose
2
1
4. Open the window and place Adapter B
through the gap. (Fig. 5)
(Fig. 1)
Note: If need to install the window kit, please
refer to the Window Kit Instruction Manual .
The hose can be extended from its
original length of 38cm up to 150cm,
but it is best to keep the length to a
minimum for efficiency. Also make
(Fig. 2)
sure that the hose does not have any
sharp bends or sags. (Fig. 6)
B
(Fig. 3)
(Fig. 4)
ENGLISH
B
13
(Fig. 5)
(Fig. 6)