Panasonic Toughbook CF-U1GQG6L2M Installation Manual page 9

Initializing Owner's Data
When you dispose the computer or transfer the ownership, initialize the owner's data to avoid the TPM-encrypted data from
being decrypted by unauthorized person.
NOTE
<For CF-U1 series Numeric Keyboard Model>
When performing the following procedure, connect the USB keyboard. Then, press the key indicated in ( ) instead of
the key or key combination which is listed immediately before.
<For CF-H1 series>
When performing the following procedure, set the computer to the cradle and connect the USB keyboard. Then, press
the key indicated in ( ) instead of the key or key combination which is listed immediately before.
1
Start the Setup Utility (
2
Select the [Security] menu, and select [Embedded Security (TPM)] and press
.
(Enter)
When you cannot enter [Embedded Security (TPM)] using the User Password, ask the administrator for the
Supervisor Password.
You cannot enter [Embedded Security (TPM)] if the Supervisor Password has not been registered.
3
Select [TPM State] and set to [Disabled].
4
Select [Pending TPM operation] and set to [Clear TPM Owner].
5
Press
Fn + F10 (F10)
The computer restarts automatically.
You will not be able to use the TPM-encrypted data after this procedure, but it will still remain on the hard disk drive. Erase
this data and all internal data using the Hard Disk Data Erase Utility.
For further information, refer to the Operating Instructions of this computer.
page 6).
, select [Yes] and press to exit the Setup Utility.
Enter (Enter)
9
Enter