Westinghouse WQE5600 User Manual page 20

20 www.westinghouse.com
Step 3 Push the tube into tap fitting past insertion
mark.
Step 4 Connect other end of tube to inlet on rear
of refrigerator.
Step 5 Turn on water and check all joints and
tubes for leaks.
Step 6 Reconnect the power.
Step 7 Move the refrigerator back into place being
careful not to kink or split the tubing.
Step 8 Switch ON Water
Dispenser. By referring
to Ice & Water on/off
function. Using a large
container, run the water
dispenser to clear air
from lines. This may take
a few minutes. Purge and
dispense a minimum of 2
litres of water. Initial water
may be black in colour.
This is residual carbon dust from the filter and is
non-toxic. If the water is slow to shut off or the
dispenser is dripping, air may still be in the lines.
Either purge more water through the system to
remove this air or allow some time for the air to be
removed over subsequent dispensing. For normal
use, water dispenser will automatically shut off
after 2 minutes of continuous operation.
IMPORTANT
As the water cut off is not instant, leave
glass under dispenser briefly until water
has stopped flowing to avoid spills. Clean
and empty the dispenser drip tray regularly
to avoid overflow. Flushing system about 2
minutes after period of non-use exceeding
30 days.
Step 9 Switch ON Ice Maker. Once the refrigerator
has been running for at least 24 hours remove the
ice bin and dispose of the first few batches of ice
to ensure that impurities have been flushed from
the system.
CAUTION
Water dispenser should not be used for
extended periods of time. After 2 minutes
of continuous use the water dispenser will
automatically shut off.
Party Ice
When the Ice Bin is removed from the cabinet the
Auto Ice Maker will continue to dispense ice into
the top freezer drawer.
IMPORTANT
• Always fit the filter as per manufacturer's
instructions.
• If you need to replace water tube, only
use approved water quality piping that
meets the pressure requirements.
• Make sure your refrigerator is level to
avoid uneven ice cubes.
• Replace filter at suggested intervals
to avoid water/ice reduction and
irregularities in taste.
• Remove and clean ice bin once a month,
discarding unused ice cubes. This will
ensure fresh, clean ice and smooth
operation of your ice maker.
• Clean and empty the dispenser drip tray
regularly to avoid overflow.