Barco UDM Series Installation Manual page 63

2
Image 5–6
3. Snap the first loop end of the safety cable into one of the following clips and let the loop end point
downwards.
1. Configuration A: Use the upper clip on the side of the cable bundle (reference 2,
2. Configuration B: Use the upper clip on the non-wired side (reference 2,
4. Slide the rest of the cable around the lens counterclockwise. Click the cable into every clip it passes in this
loop.
Note: Make sure the cable passes between the lens and the cable bundle.
5. Slide the cable through the loop end at the beginning of the cable to create a lasso..
Image 5–8 Example of configuration A
6. Pull the lasso tight around the lens body and install the U-bolt on the lens holder, with the open ends
oriented outwards (reference 3). Make sure that both a part of the loop end and the outgoing part of the
safety cable are placed in the enclosure.
1
Image 5–7
Lenses
2
1
Image 5–6).
Image 5–7).
R5911438 /08 UDM 63