EcoFlow Wave 2 User Manual
Hide thumbs
Also See for Wave 2:
- User manual ,
- Troubleshooting manual (3 pages) ,
- Quick start manual (2 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for EcoFlow Wave 2
Summary of Contents for EcoFlow Wave 2
- Page 1 EcoFlow Wave 2 User Manual V1.0...
- Page 2 Once you use this product, it is deemed that you understand, approve and accept all the terms and content in this document. EcoFlow is not liable for any loss caused by the user's failure to use the product in compliance with the Disclaimer and Safety Instructions.
- Page 3 Contents Grounding Guide Overview Light Effect Control Buttons How to Install How to Drain How to Clean...
- Page 4 Model EFKT210 Cooling Capacity/Heating Capacity 1500/1800W (5100/6100BTU) Temperature Setting Range Refrigerant R290 (130g) Air Flow Volume 290m³/h Cooling/Heating Rated Input (AC) 550W/600W (AU: 580W/600W)* Cooling/Heating Rated Input (DC) 495W/540W (AU: 520W/540W)* Maximum Cooling/Heating Power 700W AC Input Car Charging Input 12V/24V 8A, 200W max Solar Input 13A, 400W max...
- Page 5 EU/UK/CH/AU/ZA: Maximum output power: US: 0.071W EU/UK/CH/AU/ZA: 16.54dBm BR: 0.339W Maximum output power: Bluetooth US: 0.005W EU/UK/CH/AU/ZA: 0.02dBm BR: 0.147W *The parameters may vary due to local testing conditions. dioxide. working in a wet location. 4. If the product is wet inside, immediately turn the power off, remove the power cord, and place them in a safe open area.
- Page 6 10. If the product components or power cords are damaged, they must be repaired and conditions. 11. Do not place the battery where the air pressure is extremely low, as this may cause 12. Do not stand or sit on the product. 13.
- Page 7 The ground plug must be connected to a socket with a ground wire in compliance with local laws. 2. Improper ground connection may lead to the risk of electric shock. If you are not sure the EcoFlow app.
- Page 8 Safety Instructions, Quick Wave 2 Start Guide & Warranty Card Exhaust duct Exhaust duct Exhaust duct Winder adapter cover A adapter cover B adapter cover C Drain pipe Window vent board Exhaust duct D Exhaust duct E The type of AC charging cable (pluggable/embedded) varies due to local regulatory...
- Page 9 1. LCD 6. AC charging cable 2. Control buttons 3. Front air outlet fan blade 8. Solar/car charging socket (XT60) 4. Ambient light 9. Charging port cover 10. Winder socket 11. Rear air outlet 13. Drainage outlet & drainage outlet connector...
- Page 10 Pulsating blue Cooling status Pulsating orange Heating status Pulsating white Fan status Solid red Error alarm Flashing white Firmware update 7. Timer (Supported in app settings only) 2. Water level indicator 8. Remaining charge/discharge time 3. External drainage indicator 4. Cooling/Heating/Fan function 10.
- Page 11 If Wave 2 is idle for 5 minutes, the LCD and ambient light will turn off automatically (The power standby time can be set in the app). Press any button to wake them up. Press and hold it for 3 seconds to shutdown.
- Page 12 When using the cooling or heating function, please make sure you've installed the exhaust duct and adapter cover to Wave 2, otherwise it will affect the air conditioner's working When the air conditioner is used in an enclosed space, you can get rid of waste air through...
- Page 13 the board and the window, and vent the exhaust air through the ducts. It is not suggested to use the exhaust duct in rainy and snowy weather to avoid damaging the products.
- Page 14 outdoors and deliver cooling or heating through the front air outlet.
- Page 15 Do not directly remove the cable to avoid damaging the battery cell. and make sure the working current of the outlet should continuously exceed 10A . AC charging 2 series are recommended) can be used to supply power to Wave 2. These products and...
- Page 16 When charging using the car charging port, if the car battery is too low. Wave 2 supports 12V/24V car charging and a maximum charging current of 8A. Make sure that the car charging port and charging cable are securely connected to the cigarette lighter.
- Page 17 LCD for more information. When it cannot collect anymore water, Wave 2 will shut down automatically (switch to fan function if it is currently in cooling mode.). Do not shake or move the air conditioner to avoid water leakage.
- Page 18 The air inlet may get blocked with large dust particles and impurities in the air during outdoor mild detergent, dry them in the air, and then reassemble them. 1. Please close the socket cover after the unit is stored to prevent dust. 2.