Shutting Down; Battery Indicator - Panasonic Toughbook CF-51LCMDDBM Operating Instructions Manual

Dealing with Problems (Summary)
Display
When you want to display
the fonts or icons at a larger
size
During simultaneous
display, one of the screens
becomes disordered
When a video such as an
MPEG file and a DVD video
is being played with
WinDVD or Windows
Media Player, the display
destination cannot be
switched using Fn+F3
When the screensaver is
set, an error will occur dur-
ing a resume operation

Shutting down

Windows cannot be shut
down or restarted

Battery Indicator

The red indicator lights
The red indicator blinks
The green indicator blinks
26
Change the size of the icons, etc. using "Icon Enlarger" (⇒Reference Manual "Icon
Enlarger").
You can also change the settings as follows (for more details, refer to the Windows
Help).
A Select [start] - [Control Panel] - [Appearance and Themes] - [Display] -
[Appearance].
B Select the font size in [Font size], and select [Effects] and then add the
check mark for [Use large icons] to increase the icon size.
C Select [OK], then select [OK].
To enlarge a part of the screen, use Loupe Utility (⇒Reference Manual "Loupe Util-
ity").
Try changing the display by pressing Fn+F3.
If you continue to experience problems, try changing the display destination in the
following menu.
[start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) GMA Driver for
Mobile] - [Devices]
When the [Command Prompt] is set to "Full Screen" by pressing Alt + Enter, the
picture is displayed on one of the screens only. When the window display is restored
by pressing Alt + Enter , the picture is displayed on both screens.
Simultaneous display cannot be used until Windows startup is complete (during
Setup Utility, etc.). When the Fn+F3 key is pressed, the screen is displayed on the
external display or internal LCD.
The display destination cannot be switched while a video such as an MPEG file and
a DVD video is playing.
Stop playing the video before switching the display destination.
®
When the computer automatically enters the standby or hibernation mode while the
screensaver is running, an error may occur during a resume operation. In such
cases, turn off the screensaver or try changing the pattern of the screensaver.
If a USB device is connected, try removing it.
It may take one or two minutes to shut down.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light is
orange. If you do not have an AC adaptor, save your data and power off your
computer. After replacing the battery pack with a fully charged one, turn your
computer on.
Quickly save your data and power off your computer. Remove the battery pack and
disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support. The battery pack or
charging circuit may be defective.
*1
In high temperature mode, the battery pack is discharging to a level of 80%
mal temperature mode.(⇒Reference Manual "Battery Power") Do not remove the
battery pack while the battery indicator is blinking green, or the power will be turned
off forcibly.
*1
Only for the main battery pack.
*2
A level of 80% in normal temperature mode is displayed as [100%] in high temperature mode.
*2
in nor-