Fiilex Q5 COLOR User Manual

Safety Instructions
• DO NOT disassemble Q5 Color. This will void the warranty.
• DO NOT install Q5 Color in damp or wet locations.
• DO NOT obstruct the fixture's air vents.
• Use safety cable (not included) when rigging Q5 Color overhead.
• Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
• Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is
impaired, for example by cracks or deep scratches.
• The lamp shall be changed if it has become damaged or thermally deformed.
• The luminaire is intended for professional use only.
• Do not look into the light source with any instrument that could concentrate the light output: this includes magnifiers, binoculars,
telescopes, etc.
• This fixture corresponds to Risk Group 1 according to EN 62471 under normal operation condition, which considers all photobiological
risks. It corresponds to Risk Group 1 according to EN 62778 under those conditions, which considers risk from blue light only.
• The light output can potentially cause eye injury if stared at for a prolonged period of time
Parts Diagram
8
9
10
11
12
13
1. Vent Holes
2. Water Repellent Fabric
3. Power Supply Unit (PSU)
4. Latch
5. Fresnel Lens
6. Fresnel Lens Holder
7. Dual Locking V-Mount
8. Handles
9. Beam Adjustment Knob
User Guide
1
14
2
15
3
16
4
17
5
18
6
19
7
25
10. Tilt Lock Lever
11. Yoke (1/4"-20 UNC Screw Hole)
12. Baby/Junior Pin Receiver
13. Mount Tightening Knob
14. OLED Display
15. Yoke Bolt
16. Intensity Control Knob
17. CCT/HUE Knob
18. GN/SAT Knob
19. USB Type-A Port (5V/1A Power)
20. Navigation Pad
21. ON/OFF Switch
22. USB Type-C Port
(For updating firmware)
23. DMX Output (XLR-Female 5-pin)
24. DC Input Port
25. DMX Input (XLR-Male 5-pin)
20
21
22
23
24
03232023A