Zip ZULU IP-PTZ650W Quick Start Manual page 2

Hide thumbs Also See for ZULU IP-PTZ650W:

Instruction manual (17 pages)

page of 2

/ 2
Bookmarks

PTZ Control on a ZIP NVR or DVR

1. Click on the image in Live view

2. Click on the PTZ button

Mounting

1. Mark the hole

positions using the

mounting bracket

or using the

measurements on

the diagram to the

right.

Drill the holes and

install the wall

plugs.

3. Fit the PTZ to the wall using the screws provided. Ensure the PTZ cable enters via a lower position so

that water does not run down to the camera. Use silicon sealant around the base and where the cable

enters the PTZ. The connections for the camera need to be installed in a waterproof box or similar.

Connection Wires

AUDIO IN

Pink

AUDIO OUT

White/Yellow

AUDIO GND

Purple

RS485+

White/Brown

RS485-

Brown

Ground

Yellow/Green

ALARM IN

Blue

ALARM GND

Green/Purple

ALARM OUT+

Green

ALARM OUT-

Grey

All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is

made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise,

from errors or omissions in these instructions, or the performance or non-performance of the equipment refered to.

Document ref: qIP-PTZ650W

This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated

WEE/CG0783SS collection point as defined by your local council.

2. Feed the PTZ

cable loom through

the bracket, then

secure using the

short screws

provided. Attach

the safety cable

from the bracket to

the dome.

Specifications

Image Sensor