Panasonic Toughbook CF-30C3DAZBM Operating Instructions Manual page 26

Troubleshooting (Basic)
Display
The external display does
not work normally.
<Only for model with GPS>
The cursor cannot be con-
trolled properly.
Touch Pad / Touchscreen (only for model with touchscreen)
The cursor does not work.
Cannot input using the touch
pad.
<Only for model with touch screen>
Cannot input using the touchscreen.
Cannot point the correct posi-
tion using the included stylus.
Reference Manual
The Reference Manual is
not displayed.
26
If the external display does not support the power saving function, it may not work nor-
mally when the computer enters the power saving mode. Turn off the external display.
Operate the following steps.
A Restart the computer and press
B Set [GPS] to [Disable] in the sub-menu of [Serial and Parallel Port Settings] in the
[Advanced] menu of the Setup Utility.
F10
C Press and select [Yes] at the confi rmation message, and press
The computer will restart.
D Log on to Windows as an administrator.
E Click (Start) and input "c:\util\drivers\gps\GPSVista.reg" in [Start Search], and
Enter
press .
F Click [Yes], click [Yes], and click [OK].
Then restart the computer.
F2
G Press while [Panasonic] boot screen is displayed.
H Set [GPS] to [Enable] in the sub-menu of [Serial and Parallel Port Settings] in the
[Advanced] menu.
F10
I Press and select [Yes] at the confi rmation message, and press
When using the external mouse, connect it correctly.
Restart the computer using the keyboard.
Press and press two times, and press
Press , U , and R to select [Restart].
If the computer does not respond to keyboard commands, read "No response"
( page 27).
Set [Touch Pad] to [Enable] in the [Main] menu of the Setup Utility.
The drivers for some mice may disable the touch pad. Check your mouse's operating instructions.
Set [Touchscreen Mode] to [Auto] or [Tablet] in the [Main] menu of the Setup Utility.
Set [Touchscreen Mode] to [Auto] or [touch screen mode] in the [Main] menu of the Setup
Utility.
Perform the touchscreen calibration (
Install Adobe Reader.
A Log on to Windows as an administrator.
B Click (Start) and input "c:\util\reader\Setup.exe" in [Start Search] then press
Enter
.
C Update Adobe Reader to its latest version.
If your computer is connected to the internet, start up Adobe Reader and click [Help]
- [Check for Updates...].
B Click [start] - [Run], input [c:\util\reader\Setup.exe], then click [OK].
C Update Adobe Reader to its latest version.
If your computer is connected to the internet, start up Adobe Reader and click [Help]
- [Check for updates now].
F2
while [Panasonic] boot screen is displayed.
to select [Restart] and press
page 15).
Enter
.
Enter
.
.
Enter