Sending Commands; (Reservation Mode) Activating Reservation Mode - Firstech 1BAMR-Chrome User Manual

General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The single button configuration allows for keyless entry and/or
remote start functionality. Although other Firstech systems have numerous functions and capabilities, please keep in mind that your system has the option for
future upgradeability to a 2 Way system.

Sending Commands

When in range, and the button has been pressed, the remote bright blue LED will illuminate and vehicle's parking lights will flash. For example, to send a
remote start command from the remote, hold down the single button for 3.5 seconds. The remote's bright blue LED will come on solid and then flash.
Tap the single button for 1 second to lock/arm and unlock/disarm. The remote bright blue LED will flash four times indicating the signal has
been sent to the vehicle. This feature is optional and may require additional programming and/or installation. Please check with your dealer for
details.
Hold the single button for 3.5 seconds to remote start an automatic transmission vehicle. If you are in range and if the vehicle is ready to remote start, the
vehicle parking lights will flash once.
If holding the single button for 3.5 seconds to remote start the vehicle. If you see three parking light flashes, there is a remote start error. Refer to the "remote
start error diagnostic" on the last page of this manual for details.
By Firstech, LLC 6
Upon receiving confirmation that your vehicle is running, the parking lights will light solid. The remote start run time can be programmed for 3, 15, 25, or 45
minutes - ask your local Firstech dealer to adjust Option 2-7 if you would like a run time other than 15 minutes (default).
IMPORTANT: The vehicle's key must be inserted into the ignition and turned to the <on> position prior to driving your vehicle. If the foot brake is depressed
prior to the key being in the <on> position, the vehicle will shut off.
In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode. Reservation Mode must be set each and every time
you want to remote start a manual transmission vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before exiting the vehicle.
IMPORANT
The transmission must be left in the neutral position. The vehicle's door pins must be in working order.
The vehicle's windows must be rolled up. Do not set reservation mode or remote start with people in the vehicle.
Do not install this remote start on a manual transmission vehicle that has a convertible or removable top.
Activating Reservation Mode
STEP 1: While the vehicle is running, place the transmission in neutral, set the emergency / parking brake, and remove pressure from the foot brake.
STEP 2: Remove the key from the vehicle's ignition. The vehicle's engine should remain running even after the key has been removed. If the vehicle does not
remain running visit your local authorized Firstech dealer for service.
7 By Firstech, LLC