Firstech 1BAMR-Chrome User Manual page 3

Quick Reference

When servicing or loaning your vehicle to others, your system should be placed in Valet Mode. Valet Mode prevents the system from remote starting and

disables all alarm functions.

IMPORTANT: While in Valet Mode the remote will still control power lock and unlock systems. The parking lights will not flash.

The system can be put into valet one of two ways:

1. You can put the system into valet by turning the ignition key <on> and then <off> five times within 7 seconds. The parking lights will flash

once to confirm the system is in Valet Mode. Shortly after the first flash, the parking lights will flash twice.

2. (Optional Feature) If you purchased the secure valet switch option, you will not be able to put the system into valet until the proper code has been entered

with the secure valet switch. Until programmed, the default code is (3, 3).

You can exit Valet Mode through the following procedure:

On either 1 Button remote, turn the vehicle's ignition on and then tap the button 5 times, waiting a second between each tap. Your vehicle will flash the

parking lights twice and exit valet mode.

By Firstech, LLC

The only regular maintenance this system requires is remote control battery replacement.

battery.

One Button Remotes:

First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart being careful to not

touch the circuit board. The 1BAMR and 1BAMR-C and 1B900SHR-760 requires two CR2016 batteries. These specialty batteries can be purchased from your

local Firstech dealer or an electronics store.

Button

Duration

1.0 second

3.5 seconds

5 taps

No programming is required when replacing the

Function / Description

Lock/Arm. Tap again to Unlock/Disarm your vehicle

Activates the remote start. Repeat and remote start will shut off.

Takes system out of Valet Mode. Will not put into Valet Mode