Panasonic Toughbook CF-19DDGZXVM Operating Instructions Manual page 27

Starting Up
The date and time are incor-
rect.
[Executing Battery Recali-
bration] screen appears.
[Enter Password] does not
appear when resuming from
sleep ( )/standby
( )/hibernation.
Cannot resume.
Other startup problems.
Make the correct settings.
Click (Start)
and Time].
Click [start] - [Control Panel] - [Date, Time, Language, and Regional
Options] - [Date and Time].
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (
When the computer is connected to LAN, check the date and time of the server.
The 2100 A.D. or later year will not be correctly recognized on this computer.
The Battery Recalibration was canceled before Windows was shut down last time. To
start up Windows, turn off the computer by the power switch, and then turn on.
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility
( Reference Manual "Setup Utility").
The Windows password can be used instead of the password set in the Setup Utility.
A Click (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add or re-
move user accounts] and select the account, and set the password.
(Start)
B Click - [Control Panel] - [System and Security] - [Power Option] - [Require
a password when the computer wakes] and add a check mark for [Require a pass-
word].
A Click [start] - [Control Panel] - [User Accounts] and select the account, and set the
password.
B Click [start] - [Control Panel] - [Performance and Maintenance] - [Power Options] -
[Advanced] and add a check mark for [Prompt for password when computer resumes
from standby].
One of the following operations may have been carried out.
In sleep (
pack was disconnected, or a peripheral was connected or disconnected.
The power switch was slid for four seconds or longer to forcibly turn off the computer.
Slide the power switch to turn on the computer. Data not saved will be lost.
An error may occur when the computer automatically enters the sleep (
standby (
case, turn off the screensaver or change the pattern of the screensaver.
F9
Press in the Setup Utility (
Setup Utility settings (excluding the passwords) to the default values. Start the Setup
Utility and make the settings again.
Remove all peripheral devices.
Check to see if there was a disk error.
A Remove all peripheral devices including an external display.
B Click (Start) - [Computer] and right-click [Local Disk (C:)], and click [Properties].
C Click [Tools] - [Check Now...].
A standard user needs to enter an administrator password.
D Select the option in [Check disk options] and click [Start].
E Click [Schedule disk check] and restart the computer.
A Click [start] - [My Computer] and right-click [Local Disk(C:)], and click [Properties].
B Click [Tools] - [Check Now].
C Select the option in [Check disk options] and click [Start].
Start the computer in Safe Mode and check the error details. When the [Panasonic] boot
*1
screen disappears at startup, press and hold
Menu is displayed. Select the Safe Mode and press
*1
When [Password on boot] is set to [Enabled] in the [Security] menu of the Setup Utility,
[Enter Password] appears after the [Panasonic] boot screen disappears. As soon as you
enter the password and press
- [Control Panel] - [Clock, Language, and Region] - [Date
page 37).
) / standby (
) or hibernation mode while the screensaver is active. In this
Reference Manual "Setup Utility") to return the
F8
until the Windows Advanced Options
Enter
, press and hold
) mode, the AC adaptor or battery
Enter
.
F8
.
) /
27