Table of Contents
Advertisement
6. EXPLANATION OF THE CONTROL PANEL
!4
2 4
3 5
Pattern selector switch
1
• Used for selectng a pattern from among the
four dfferent patterns.
Double reverse stitching (for start) switch
2
• Used for turnng ON/OFF the double reverse
sttchng for start.
Double reverse stitching (for end) switch
3
• Used for turnng ON/OFF the double reverse
sttchng for end.
Automatic reverse stitching (for start) switch
4
• Used for turnng ON/OFF the automatc
reverse sttchng for start.
Automatic reverse stitching (for end) switch
5
• Used for turnng ON/OFF the automatc
reverse sttchng for end.
Switches for setting the number of stitches
6
• Used for settng the number of sttches to be
sewn n processes A through D.
Material edge sensor ON/OFF switch
7
• Rendered effectve when the materal edge
sensor s nstalled on the machne.
• Used for settng whether or not the materal
edge sensor s used durng sewng.
One-shot automatic stitching switch
8
• Rendered effectve when the materal edge
sensor s nstalled on the machne or when
the sewng machne s operated under the
constant-dmenson sttchng mode.
• Start the sewng machne wth ths swtch, and
the sewng machne wll run automatcally untl
the materal edge s detected or the end of a
constant-dmenson sttchng s reached.
Automatic thread trimming switch
9
• Rendered effectve when the materal edge
sensor s nstalled on the machne or when
the sewng machne s operated under the
constant-dmenson sttchng mode.
• Even keep depressing the front part of the
pedal, the sensor can detect the materal
edge, or after the completon of the constant-
dmenson sttchng mode, the machne wll
automatcally perform thread trmmng.
1
6
Thread trimming prohibition switch
!0
• Used for prohbtng thread trmmng at any occason.
Bobbin thread counter/thread trimming counter
!1
• Bobbn thread counter/thread trmmng counter
can be changed over by the functon of the control
box man body.
Bobbin thread counter :
• Indcates the amount of bobbn thread whle
countng t by subtractng from the set value.
• When the bobbn thread remanng amount
detectng devce s nstalled on the machne, the
counter ndcates the number of tmes of detectng.
Thread trimming counter :
• Every tme thread trmmng s performed, the
counter value s added.
Bobbin counter reset switch
!2
• Used for returnng the value shown on the
bobbn thread counter to the ntal value.
• When the thread trmmng counter s selected,
t s reset to [0].
Bobbin thread amount setting switch
!3
• Used for settng the amount of bobbn thread.
Needle up/down compensation switch
!4
• Used for performng needle up/down
compensaton sttchng.
[Changeover selection of needle bar stop position
when the pedal is in its neutral position]
• Pressng the needle up/down compensaton
swtch, turn ON the power to the machne, and
the needle bar stop poston when the pedal s
n ts neutral poston s changed over to down
poston/up poston.
• Confirmation of the stop position can be
performed at the front cover of the control box.
When up position stop is specified : " nP UP "
When down stop position is specified : " nP Lo "
Information switch
!5
• Used for callng the producton support
functon and callng the one-touch settng
(by keeping the switch held pressed for one
second.)
- 4 -
7
8
!2
!1
9
!5
!0
!3
Advertisement
Table of Contents
