Outdoor Unit Installation - York HP Series Service Manual

Remove the 4 corner covers.
Hang the panel to the hooks on the mainbody. If
the panel is with auto-lift grille, please watch the
ropes lifing the grille, DO NOT make the ropes
enwinded or blocked.
Tighten the screws under the panel hooks till
the panel closely stick on the ceiling to avoid
condensate water.
Hang the air-in grill to the panel, then connect
the lead terminator of the swing motor and that
of the control box with corresponding
terminators on the body respectively.
Install the 4 corner covers back.
Note: The panel shall be installed after the
wiring connected.

13.3 Outdoor unit installation

13.3.1 Service space for outdoor unit
Air inlet
More than 30cm
(11.81in)
Air inlet
Air outlet
62
(Wall or obstacle)
More than 30cm(11.81in)
Maintain channel
More than 60cm
(23.62in)
More than 200cm(78.74in)