Introduction; Laser Safety - Novanta ventus with mpc6000 User Manual

INTRODUCTION

Introduction
The ventus is a Diode-Pumped Solid-State (DPSS) laser system emitting light in the visible region of the spectrum at
532 nm, 561 nm, 660 nm or 671 nm, depending on the variant ordered. It is a Class 3b or Class 4 laser product. This
manual describes the set-up requirements and operational procedures to ensure safe operation of the system.
Use of controls or procedures or performance of procedures other than those specified herein may result in
hazardous radiation exposure. Use laser ONLY for the originally intended requirement such as for
scientific research, industrial application or for oem integration.
Operational Requirement: Electrical Specification
The mpc6000 Power Supply Unit (PSU) requires:
Input Voltage 12 V DC Acceptable range 11 V to 14 V (Ripple 1% peak to peak)
Input Current 8 A Minimum of 8 A must be available from the external source
Important Note: The centre pin of the input connector is positive, and the external DC source output shall
not be referenced to mains ground.
Operational Requirement: Environment
Optimal Operating Temperature Range – Laser Head
Maximum Operating Temperature – Laser Head
Maximum Operating Temperature – PSU
For optimal performance, the laser head should be mounted onto an appropriate heatsink in a stable environmental
temperature. The heatsink requirements will depend on the ambient temperature of the operating environment and
the operating power of the laser (section 6).
In the event of the laser head or PSU over-heating, a controlled shut down of the system will occur (Section 6). The
system can only be restarted once it has been cooled to a safe temperature.
Temperature Range:
Humidity:

Laser Safety

Warning: Serious Personal Injury
5ºC to 45ºC
Non-Condensing
22ºC to 37ºC
40ºC
40ºC
PAGE | 5