Lenovo ThinkSystem SR655 V3 User Manual page 94

– Handle memory modules with care: never bend, twist, or drop a memory module.
– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr655v3/7d9e/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 190
Watch the procedure
A video of this procedure is available at YouTube:
BashWCNZQEDP7o3EohXPEV
Procedure
Step 1. Locate the required memory module slot on the system board assembly.
Note: Ensure that you observe the installation rules and sequence in
rules and order" on page
Step 2. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 3. Install the memory module into the slot.
Attention:
• To avoid breaking the retaining clips or damaging the memory module slots, open and close the
clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
ThinkSystem SR655 V3 User Guide
84
for more information on firmware updating tools.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
39.
"Memory module installation