Table of Contents
Advertisement
Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Insufficient cleaning.
Cause and troubleshooting
Start the
programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the
programme.
▶
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Check whether the detergent used is suitable.
1.
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 50
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispenser", Page 44
Basic dosage is not correctly adjusted.
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 45.
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Check whether the detergent used is suitable.
1.
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 50
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispenser", Page 44
Basic dosage is not correctly adjusted.
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 45.
Basic dosage is not correctly adjusted.
If intelligent dosing is activated, adjust the basic
▶
dosage → Page 45 correctly.
Troubleshooting en
65
Advertisement
Table of Contents
