Table of Contents
Advertisement
en Troubleshooting
Fault
"E:36 / -10"
"E:36 / -25 / -26"
"E:10 / -00 / -10 /
-20"
flashes.
58
Cause and troubleshooting
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
Drain pump is blocked.
→ "Cleaning the drain pump", Page 52
▶
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 50
If this indicator appears again, call our after-sales
3.
service.
→ "Customer Service", Page 70
Note: You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→ "Buttons", Page 24
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow → Page 55.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 50
Push the detergent drawer in as far as it will go.
2.
The automatic voltage control system detects an un-
authorised voltage under-usage.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Advertisement
Table of Contents
