1. Manuals
  2. Brands
  3. Furniture of America Manuals
  4. Indoor Furnishing
  5. CM7504Q/EK/CK
  6. Assembly instructions

Furniture of America CM7504Q/EK/CK Assembly Instructions

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Assembly Instructions
For more information contact our team: service.ec@foagroup.com
CM7504Q/EK/CK

ASSEMBLY RATING

Tools Required For Assembly:
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
Phillips Screwdriver
easy and 5 being difficult). For some
(Not Included)
products, two persons are recommended.
DIFFICULT
EASY
2 PERSONS RECOMMENDED
Page 1 of 5
Rev: 18-03-05

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM7504Q/EK/CK and is the answer not in the manual?

Questions and answers

Related Manuals for Furniture of America CM7504Q/EK/CK

Summary of Contents for Furniture of America CM7504Q/EK/CK

  • Page 1 Assembly Instructions For more information contact our team: service.ec@foagroup.com CM7504Q/EK/CK ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being Phillips Screwdriver easy and 5 being difficult).
  • Page 2 LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY. FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. FURNITURE OF AMERICA.ALL RIGHTS RESERVED. Page 2 of 5...
  • Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #A x 29pcs #1 x 1pc Headboard Screw #1/8" x 1-3/8" #2 x 1pc Footboard #5 x 4pcs Ø5/16"...
  • Page 4 Align and latch the hooks to the side rails (#3) to the slits of the headboard (#1) and footboard (#2). Make sure it is firmly in place. Attach support legs (#5) to the support rail (#6). Adjust the adjustable floor protectors on the support legs (#5) according to ground level. Page 4 of 5...
  • Page 5 Align support rail (#6) to the holes of the slat kit (#4), then secure by using screws (#A). #A x 3pcs Align slat kit (#4) to the side rails (#3), then secure by using screws (#A). #A x 26pcs Page 5 of 5...

Table of Contents