Larson Electronics LEDWP-LP-450-KNL-DCM Instruction Manual

5100 Lumens - 120-277V AC - IP66 Rated - Knuckle Mount
Thank you for your purchase of the Larson Electronics LEDWP-LP-450-KNL-DCM LED Flood Light.
Please follow the steps below in order to install, operate and maintain this product.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE LEDWP-LP-450-KNL-DCM MUST BE WIRED IN ACCORDANCE WITH NATIONAL
ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,
CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
RISK OF PERSONAL INJURY –
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.

MOUNTING

The LEDWP-LP-450-KNL-DCM is mounted with 1/2" Knuckle Mount made of die-cast aluminum, which
provides operators with mounting flexibility in a variety of locations.
1. Begin by choosing a location to install the fixture. This LED flood light is suitable for outdoor use where the
potential exposure of ultraviolet light, moisture or full water immersion exists. The LEDWP-LP-450-KNL-DCM
operates in extreme temperatures from -40ºC to 45ºC and includes an unbreakable polycarbonate lens that
protects the LEDS against the buildup or intrusion of dust, dirt and humidity.
2. Affix the mount to your chosen surface. Plan a way for wiring to connect such as using a separate junction
box and utilize the cord grip where necessary.
3. Attach lamp. The lamp is attached to the knuckle mount via mount holes on the bottom of the fixture. A single
bolt on each side secures the lamp to the mount.

WIRING

We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required. Universal voltage driver permits operation at 120V - 277V AC, 50
or 60Hz.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light
fixture wires as shown in the diagram 
Secure each pair with a wire nut according to the
diagram. Utilize a junction box or similar device and
take precautionary steps for weatherproofing all
connections if installed in a location where water may
come in contact with the unit. Ensure the unit is
properly grounded.
Larson Electronics, LLC
45 Watt LED Flood Light
Instruction Manual
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
Phone: (800) 369-6671 Fax: (903) 498-3364
LEDWP-LP-450-KNL-DCM
www.larsonelectronics.com 1 of 2