System Installation - SMART Embedded Computing SE1700 Manual

Safety Notes
Use only shielded cables when connecting peripherals to help assure that appropriate radio
frequency emissions compliance is maintained. For proper EMC shielding, only operate the
system with face plates installed and all vacant slots covered or populated with filler cards.
Grounding
If the product is not properly grounded, it may be damaged by electrostatic discharge.
The system contains EMI gaskets at the shelf and module level. Make sure that each of the
system's parts contact the EMI gasket.
This is a Class A product based on the standard of the Voluntary Control Council for
Interference by Information Technology Interference (VCCI). If this equipment is used in a
domestic environment, radio disturbance may arise. When such trouble occurs, the user
may be required to take corrective actions.

System Installation

System is to be installed in a restricted access location by trained personnel
according to the installation instructions.
Read all installation instructions in the product manual before you install the
system.
System Damage
To avoid system damage verify that the system environment meets the environmental and
power requirements given in this manual before installing the system. Before you set up
and cable your new system, consider these guidelines:
Restricted access location: Intended for installation in a restricted access location

with access by trained personnel only.
Installation codes: Where applicable, this unit shall be installed in accordance with

the National Electrical Code (NEC).
Overcurrent protection: A readily accessible listed branch circuit overcurrent

protective device must be incorporated into the building wiring. For appropriate
AWG rating of the overcurrent protection device, see NEC Table 310.16 and other
national regulations.
The protective bonding conductor depends on your power distribution topology.

Make sure that you use an appropriate protective bonding conductor regarding the
rating of the branch circuit protection.
Install the system safely. Make sure that cables and cords are out of the way.

Make sure that the set-up is comfortable for users.

6 SE1700 SMART Edge Server Safety Notes Summary (6806876A02B)
Safety Notes