SMART Embedded Computing SE1700 Manual page 7

System Damage
WARNING: The intra-building port (s) of the equipment or subassembly is suitable for
connection to intra-building or unexposed wiring or cabling only. The intra-building port (s)
of the equipment or subassembly MUST NOT be metalically connected to interfaces that
connect to the OSP or its wiring. These interfaces are designed for use as intra-building
interfaces only (Type 2 or Type 4 ports as described in GR-1089) and require isolation from
the exposed OSP cabling. The addition of primary protectors is not sufficient protection in
order to connect these interfaces metalically to OSP wiring.
System Damage
All interconnected equipment to this equipment (or to added subassemblies) is intended to
be within the same building. If this equipment (including any added subassemblies) is used
in inter-building connection, the connection shall be adequately protected against over-
voltage/transient. And further Electrical Safety evaluation would be required.
System Damage
Environmental contamination can impair system operation.
Locate the system in a stable area free of excess movement and jarring and free of dust,
smoke, and electrostatic discharge (ESD).
Make sure that the temperature does not exceed the operating temperature given in the
environmental requirements in this manual and allow room for proper air flow for cooling.
Personal Injury or System Damage (For AC)
The system is supplied by AC mains primary voltage. This voltage is considered
hazardous. Take appropriate precautions when cabling the system.
Personal Injury or System Damage
Stability Hazard
The rack may tip over causing serious personal injury.
A top-heavy rack can tip, causing damage to equipment and injury to personnel.
SE1700 SMART Edge Server Safety Notes Summary (6806876A02B)
Safety Notes
7