Figure 17 Telnet Com Port Option Client Tool Execution Example - Wiznet WIZ1000-US User Manual

can accept the request, it will reply the other side with a "DO" command, otherwise, the
"DON'T" command will be replied. The Com port configuration procedure can be started only
if the "DO" reply is received from WIZ1000. For each command, the value of 0 is used to
query the current settings of WIZ1000. After any setting, the "Over!" button should be clicked
to tell WIZ1000 that the configuration is over. If the value of any parameter is changed,
WIZ1000 will reboot again to apply it.
Since WIZ1000 is a gateway between Com port and Ethernet, only the basic Com port options
are supported. Such as "Set Line State Mask", "Set Modem State Mask" and "Set Purge Data",
are introduced in RFC2217, but not supported by WIZ1000. The supported Com port options
and the corresponding value are list in Table 9. For more detailed introduction of Telnet Com
port options, please refer to RFC2217.
Figure 17 User interface of Telnet Com Port Option
Copyright © WIZnet All Rights Reserved WIZ1000 | 31 page
Downloaded from Elcodis.com electronic components distributor