2.2.
ⓐ
The current version of the firmware of selected WIZ1000 is displayed in this field.
ⓑ
socket message of WIZ1000 (listen OK, connect fail etc.) through serial terminal. If Debug
mode is on, debug message can cause abnormal operation of the serial device. Therefore,
just use this mode only for Debug mode.
ⓒ
Copyright © WIZnet All Rights Reserved
Downloaded from
Elcodis.com
electronic components distributor
Configuration Tool
2.2.1.
Network Configuration
ⓐ
ⓒ
Figure 2. User Interface of Configuration Tool (Configuration via Network)
Version : Displays firmware version.
Enable Serial Debug Mode : If this mode is checked, you can monitor the status and
Board List : If you click "Search" button, all the MAC addresses on a same subnet, will be
ⓑ
ⓓ
ⓔ
ⓕ
ⓖ
ⓗ
ⓘ
ⓙ
ⓚ
ⓛ
ⓜ
ⓝ
ⓞ
ⓟ
ⓠ
WIZ1000 | 11 page