B&B Electronics Conel XR5i v2 User Manual page 33

10. FAQ
I can't get from internet on equipment, which is connected to router and I have NAT en-
abled.
The device's gateway has to be configured as the router.
Router resets itself, connection on Ethernet fails.
It is necessary to use an antenna, which will be situated far from power supply.
I don't get on web server at NAT.
The remote http access of the router has to be disabled, default server address has
to be your web server and the gateway of the web server has to be the IP of router.
Connection fails on Ethernet or connection isn't establishing.
On ethernet interface of the router it is possible to switch auto negotiation off and
set a rate and duplex by hand.
DynDNS not function.
In private APN not functional.
If the same IP address is recorded in your canonic name as dynamically assign
address, it means that the operator is using NAT or firewall.
NAT is possible to verify by the help of the ping on address of your server with static
IP address and by the help of the router address verify and address in ping.
Firewall is possible to verify, for example by remote access on web interface.
The operator doesn't give out address DNS servers and without DNS server's it
is impossible to connect to server dyndns.org. In log system will be this message:
– DynDNS daemon started
– Error resolving hostname: no such file or directory
– Connect to DynDNS server failed
IPSec tunnel is establishing but communication doesn't function.
Probably it is badly set up route conditionals of connected equipment or it is bad set
up GW.
FTP doesn't function.
Router doesn't support the active FTP mode, supports the passive mode only.
27
10. FAQ