Table of Contents
Advertisement
56
EN
SYMPTOM
39. An error indication
(E01 — E06) appears.
40. The charger indicator on
the AC Power Adapter/
Charger does not light.
41. Picture does not appear on
the LCD monitor.
42. When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
43. When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
Downloaded from:
39. •A malfunction of some kind
40. •The temperature of the
•Charging is difficult in
41. •The lens cap is attached.
•The LCD monitor's
42. •This is not a malfunction.
43. •The DV cable was plugged/
https://www.usersmanualguide.com/
TROUBLESHOOTING
POSSIBLE CAUSES
has occurred. In this case
the camcorder's functions
become unusable.
battery is extremely
high/low.
places subject to extremely
high/low temperatures.
brightness setting is too
dark.
unplugged with power
turned on.
CORRECTIVE ACTION
39. •Remove the power supply
(battery pack, etc.) and wait
a few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
40. •To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 35°C (
41. •Remove the lens cap
(
pg. 12).
•Adjust the brightness of the
LCD monitor (
pg. 12).
•If the monitor is tilted
upward 180 degrees, open
the monitor fully (
42. •By recording with "DIS"
activated (
pg. 22) this
can be avoided.
43. •Turn the camcorder's power
off and on again, then
operate it.
(cont.)
pg. 63).
pg. 13).
Advertisement
Table of Contents
