Additional Features; Second Car Mode; Adding An Additional Remote - CompuSTAR 2000R Owner's Manual

A D D IT I O NA L F EA TU R ES A D D IT I O NA L F EA TU R ES
A D D IT I O NA L F EA TU R ES A D D IT I O NA L F EA TU R ES
The CompuStar 2000AS remote-pager has additional features and expansion
possibilities.
S e c o n d C ar M o d e S e c o n d C ar M o d e S e c o n d C ar M o d e S e c o n d C ar M o d e
CompuStar 2000AS remote-pager can be programmed to operate a second vehicle.
Press Buttons (III+IV) simultaneously for a ½ second to enter second car mode. A
red–bordered indicator box labeled 2
CompuGlo LCD will darken illustrating that your are in this mode.
If you are in second car mode, you can program your remote-pager to the second
vehicle by following the steps illustrated in the section below entitled "Adding an
Additional Remote-Pager." In order to exit second car mode, press Buttons (III+IV)
simultaneously again. Please contact your local authorized CompuStar dealer for
more information.
A d di n g a n A d di ti o na l R em o t e A d di n g a n A d di ti o na l R em o t e - - - - P a g er A d di n g a n A d di ti o na l R em o t e A d di n g a n A d di ti o na l R em o t e
Your remote-pager has been programmed at the factory. However, if you replace or
add an additional remote-pager, please perform the following:
Steps 1: Put the system in Valet mode with the key by turning the ignition on and off
five times with the mechanical car key within 10
once.
Step 2: Within 6 seconds, press Button I for a ½ second.
Step 3: The parking light will flash twice to confirm Step 2.
Step 4: Program the second transmitter or third transmitter by pressing any button.
The system will program up to 3 transmitters. The parking light will flash once to
confirm Step 3.
©
located on the top left-hand corner of your
nd
P a g er P a g er P a g er
seconds. The parking light will flash
2001 Firstech, Inc. Page 14