Kashino Technology CSN-A1K User Manual page 53

CSN-A1K User manual
m Print mode
1, 49 Partial cut (one point left uncut)
Feeds paper (cutting position + [n × 0.125 mm]), and cuts the paper
66
partially (one point left uncut).
[Notes for ① and ②]


[Note for ① ] Only the partial cut is available; there is no full cut.
[Notes for ②] 

ESC P m t1 t2 (for Drawer)
[Name] Generate pulse
[Format] ASCII:
Decimal:
Hexadecimal:
[Range] m=0,1,48,49
0≤t1≤255, 0≤t2≤255
[Description] Outputs the pulse specified by t1 to connector pin m as follows:
m Function
0,48 Drawer kick-out connector pin2.
1,49 Drawer kick-out connector pin5.
[Note] 

ESC c 5 n(for buttons)
[Name] Enable/disable panel buttons
[Format] ASCII:
Decimal:
Hexadecimal:
[Range] 0≤n≤255
[Description] Enable/disable panel buttons（support the panel buttons）


[Default] n=0
Cutting status is different, depending on the installed autocutter type.
This command is effective only when processed at the beginning of a
line.
When n=0, the printer feeds the paper to the cutting position and
cuts it.
When n≠0, the printer feeds the paper to (cutting position+[n×0.125
mm (0.0049")]) and cuts it.
The pulse ON time is [t1×2ms] and the OFF time is [t2×2ms].
If t2<t1, the OFF time is [t1×2ms].
When the LSB of n is 0, the panel buttons are enabled.
When the LSB of n is 1, the panel buttons are disabled.
ESC p m t1 t2
27 112 m t1 t2
1B 70 m t1 t2
ESC c 5 n
27 99 53 n
1B 03 35 n
/
53 72