Table of Contents
Advertisement
Malfunction
Loud noise during
spin.
Clapping, rattling
in the pump.
Slurping, rhythmic
suction sound.
Creasing.
Detergent or fabric softener
softer drips from
the cuff and collects on
the door or in the cuff
crease.
Centrifuge result is
not satisfied-
ity. The laundry is too
wet / too damp.
Cause and Troubleshooting
Secure the device feet.
▶
→ "Adjusting the device", page 16
Transport protection devices have not been removed.
→ "Remove transport protection", page 14 .
▶
A foreign object has entered the pump.
→ "Clean the drain pump", page 36
▶
Pump is active, the suds are pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load amount is too high.
Reduce the load amount for the next wash.
▶
Unsuitable program for the type of fabric set.
Choose a suitable program for the type of fabric.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing the liquid detergent and fabric
▶
softener, pay attention to the marking in the
detergent drawer and do not exceed it.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Launch the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
trapped.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or trapped.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
TroubleshootingNL
47
Advertisement
Table of Contents
