SMA UTV-65-7 Owner's Manual

Model: UTV-65-7 (5302830)
(65 Gallon Lawn & Garden UTV Sprayer w/7-Nozzle Boom)
Technical Specifications

65 Gal. Corrosion-Resistant Polyethylene Tank

Deluxe Pistol-Grip Handgun

25 Ft. Handgun Hose

26' max. vertical throw, 35' horizontal throw

7-Nozzle Boom Assembly (140" Spray Coverage)

Adjustable Boom Height

12 Volt, 3.8 GPM Diaphragm Pump

Multi-Lid to accurately measure and pour chemicals
Caution: When fully filled with water, this sprayer will
weigh 640 lbs.. Consult the owner's manual for your
vehicle to verify that you are within it's load carrying
capacity.
Secure unit in your UTV, using tie-down straps
(NOT INCLUDED)
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-870-935-3291
If you should have a question or experience a problem with
your SMA Product: call the Toll free number above.
Our technical support representatives will be happy to
help you. In most cases a customer service rep. can
resolve the problem over the phone.
To obtain prompt, efficient service, always remember to give
the following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your
utility sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.
Warranty
Products are warranted for one year from date of purchase
against manufacturer or workmanship defects for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information...

Correct Part Description and/or part number

Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
OWNER'S MANUAL
Assembly Instructions
The sprayer is partially assembled at the factory. Follow the
assembly instructions on page 2 and hook up the wiring to an
existing 12 volt power source to complete your sprayer.
Connect the electrical hook-up to the end of your pump and
clip the clips to a fully charged battery. The red wire must be
connected to the positive (+) and the black wire should be
connected to the negative (-).
Read the operating instructions and then run the sprayer
using only water for testing. When everything tests all right,
add the desired chemical mixture and water combination and
start the spraying operation.
***IMPORTANT REMINDER***
This sprayer comes with an On/Off valve located on your intake
line. You must make sure the valve is in the "open" position before
using your sprayer.
Jonesboro, AR 72401
Phone: 870-935-3291 Fax: 870-935-5651
5008503
(02/16)
Page 1