M-system R7L-RS4-R Instruction Manual page 19

■ FUNCTIONAL BLOCK: fbDIEX[0...7]
• Network Variables
Normal Mode
TYPE
NETWORK
{ Range }
VARIABLE
{ Default }
{SNVT_switch}
nvoDIEX1 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
{SNVT_switch}
nvoDIEX2 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
Combination Mode
TYPE
NETWORK
{ Range }
VARIABLE
{ Default }
{SNVT_switch}
nvoDIEX1 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
{SNVT_switch}
nvoDIEX2 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
• Configuration Properties
CONFIGURATION NETWORK
PROPERTY VARIABLE
SCPTdirection ----
SCPTinvrtOut nvoDIEX1
SCPTinvrtOut nvoDIEX2
SEN TRONIC
EXPLANATIONS
Outputs X0, X2, X4, X6, X8, XA, XC, XE status of the extension module
Outputs X1, X3, X5, X7, X9, XB, XD, XF status of the extension module
EXPLANATIONS
Contact input, nvoDIEX1 and nvoDIEX2 Reference Table
X0
X2
X4
X6
X8
XA
XC
XE
OFF
ON
OFF
ON
TYPE
{ Range } EXPLANATIONS
{ Default }
{SNVT_state} Bit 0, Bit 1: fbDIEX operating mode
{0 or 1} 0,0 : Normal mode
{0,0,0,0,0,0,0,0, 0,1 : Combination mode
0,0,0,0,0,0,0,0} Bit 2 through 15 : Invalid
{SNVT_lev_disc} Contact input logic is inverted at nvoDIEX1.
{ST_OFF, ST_ON} ST_OFF : OFF at open contact, ON at closed contact
{ST_OFF} ST_ON : ON at open contact, OFF at closed contact
{SNVT_lev_disc} Contact input logic is inverted at nvoDIEX2.
{ST_OFF, ST_ON} ST_OFF : OFF at open contact, ON at closed contact
{ST_OFF} ST_ON : ON at open contact, OFF at closed contact
056 222 38 18 mailbox@sentronic.com
AG
X1
X3
X5
X7
nvoDIEX1 nvoDIEX2
X9
XB
XD
XF
OFF 0.0 0 (OFF) Invalid
OFF 100.0 1 (ON) Invalid
ON 0.0 0 (OFF) 0.0 0 (OFF)
ON 100.0 1 (ON) 100.0 1 (ON)
EM-7804-C Rev.5 P. 19 / 19
www.sentronic.com
R7L-RS4