Table of Contents
Advertisement
No.
Feature
Setup DIP switches
9.
Power Connector
10.
6
INSTALLATION
6.1
Rack Mounting
Each of the Matrix Switchers described in this manual may be rackmounted in a standard 19" (1U) EIA rack
assembly and includes rack "ears" at the ends of the front panel. These devices do not require spacing above or
below the unit for ventilation. To rack mount any of the Matrix Switchers, simply place the unit's rack ears
against the rack rails of the rack, and insert standard screws through each of the four corner holes in the rack
ears.
7
CONNECTING TO VIDEO DEVICES
Video sources and output devices (such as monitors, or recorders) may be connected to the Matrix Switchers
through the BNC type connectors located on the back of the unit. Bear in mind that the output signal format will
match that of the input signal format.
All signal connections that use more than one cable interconnecting between devices should be of equal length.
(Example: cables between a camera and the machine should be equal in length).
8
CONNECTING TO AUDIO DEVICES
Audio sources and output devices (such as amplifiers or recorders) may be connected to the machines through
the RCA type connectors (CVG-808
9
USING THE MACHINES
9.1
Powering on the Machine
1. The machine should only be powered on, after all connections
2. The socket-outlet should be near the equipment and should be
1.
Press the toggle switch on the far left-hand side of the front panel to the ON position. The toggle switch
glows.
2.
Operate the acceptors.
9.2 Using the Front Panel Controls
The front panels of CVG Matrix Switcher are designed to be simple to operate, and accomplish the basic
function of selecting an input source and output device.
Selecting an Output
9.2.1
Output selection on the Matrix Switchers is made by pressing any of the buttons marked "1" through "8" (CVG-
808
), or "1" to "6" (CVG-606
XL
marked on the back panel.
Allow proper configuration of the control signals received and transmitted
through the RS-232 (or RS-485) control port, master/slave modifications, line
termination and device ID numbers.
A 3-prong AC connector allows power to be supplied to the unit. Directly
underneath this connector, a fuse holder houses the appropriate fuse.
, CVG-606
XL
are completed, and all source devices have been powered on.
Do not attempt to connect or disconnect any video, audio or
control signals to the machine while it is powered on!
easily accessible. To fully disconnect equipment, remove
power cord from socket.
) on the front panel. These buttons correspond to output connections as
XL
Function
Operation of the machine from a remote PC
may be done using the control software
(provided with the machine) .
).
XL
NOTES
8
Advertisement
Table of Contents
