Typical Applications; Basic Video-Audio Setup; Component Switching Using Multiple Matrix Switchers; Figure 6: Basic Video-Audio Setup - Comprehensive CVG-606xl User Manual

Comprehensive video video/audio matrix switcher user manualcvg-606xl , cvg-808xl
Hide thumbs Also See for CVG-606xl:
Table of Contents

Advertisement

10

TYPICAL APPLICATIONS

10.1 Basic Video-Audio Setup

One of the most common video formats is composite video. Figure 7 describes a typical composite video setup
using the CVG-808
source are connected to the machine, while control of the Matrix Switcher is implemented via the PC using RS-
232 communication.
Perform the following steps (as necessary):
1. Connect all video-audio sources to the video-audio inputs of the Matrix Switcher.
2. Connect all video-audio acceptors to the video-audio outputs of the Matrix Switcher.
3. Operate the Matrix Switcher, PC sources and acceptors.
4. Select the required video input to be switched, using front panel input selector pushbuttons (or the software
program controls).

10.2 Component Switching using Multiple Matrix Switchers

A commonly used video format is component video, and switching the three signals (components)
simultaneously is sometimes a complicated task. Using several Matrix Switchers, however, this can be done
very easily and efficiently. This is done by dedicating each switcher to a single component.
For example, for an 8 input, 8 output RGBS matrix switcher, 4 CVG-808xl's would be used – one for the Red
component, one for Green, one for Blue, and one for Sync. Each component of the RGBS signal is then
connected to the same input (or output) number on the switcher. For example, the first RGBS source is
connected to Input #1 on the 4 switchers, the second is connected to Input #2 on the switchers, etc. The
switchers are configured to mirror each other, so the input to output connections are identical on all 4 machines!
In order to switch during the vertical interval when working in this way, the switchers should be configured for
operation using the "Ext. Sync". A sync source should then be connected to all the machines (for RGB this
could be the Green channel, and for YUV this could be the Y channel).
in this case. Three video-audio sources, three video-audio acceptors, and a genlock
XL

Figure 6: Basic Video-Audio Setup

12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cvg-808xl

Table of Contents