Connections - Panasonic Viera TH-65PHD7 Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
SPEAKER
Terminal (R)
1 Connect the AC cord plug to the Plasma Display.
2 Fix the left side clamper.
3 Fix the right side clamper.
Note: The power plug in the illustration may not be the type fitted to your set.
– Cable fixing bands Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
– AC cord fixing
2
To secure cables connected to Terminals, wrap the cable fixing band around them
then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially
in the power cord), firmly bind all cables with the supplied fixing band.
2
R L
AUDIO VIDEO IN VIDEO OUT
IN
AV
S VIDEO IN
SLOT2
COMPONENT/RGB IN
AV Terminals
and Audio IN Terminals
(see page12)
(see page12)
SPEAKER
Terminal (L)
1
3
To tighten:
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal on
Computer (see page 10)
1
2
2
Close
Push until the hook clicks.
Open
2. Pull off.
1. Keep the knob pressed.
To loosen:
Keep the knob
pressed.
AUDIO
PC IN SERIAL
From SERIAL
Terminal on Computer
(see page 11)
1
Pull
9