Advertisement
Step 2:
Slip-in the M8 (5) – 4 off, as
shown, and secure the threads in
the Countersink screws.
Ensure a Square fit on the surface
of the Rear Panel/Spacer and
tighten it to torque, as per
specifications in the BOM Table.
Copyright By SRC
Design and Specification are subjected to change
Step 1:
Orient and Align the Top Rack (1), as
shown, in-line with the Mounting
holes of the Rear Panel.
Slip-in the Taper Ring M8 (2) – 4 off,
Countersink Screw M8 x 40 (3) – 4 off
from the top, and Slip-in the Spacer
(4) – 4 off underneath the Top rack,
and on Top of the Mounting holes in
the Rear Panel.
Top
Rack
in
final
condition, is as shown above.
mounted
Page 3
Advertisement
