Other Weather Station Features; Backlight: Does This Station Have A Backlight; What Is Auto Dim - La Crosse Technology V50EU Faq

Hide thumbs

Table of Contents

•

SEE APP TO CONNECT appears at start up is a prompt to connect to the La Crosse View™ app.

•

LOST WIFI again refers to your station searching for a WIFI connection to connect to the

app. You station has found a Wi-Fi service and is awaiting a password.

•

These statements should only flash for a few minutes then disappear.

•

They may show again for a few minutes if you restart the station or press and release the SET button.

When connected you will have these and other status messages available with a press of the SET button.

ALL OK CONNECTED:

o Station is connected all the way through to your app.

LOST WIFI:

o Check your 5 volt power cord connection (power cord required to connect)

o When trying to reestablish your station's Wi-Fi connection, be sure your mobile device is on the same

2.4GHz network you want your station to use.

o Enter your Wi-Fi password again.

o Check your network connection.

o Hold the + and – buttons together for 3 seconds to search for Wi-Fi.

NO WEATHER SERVICE:

o Wi-Fi, and App are fine.

o Weather/Time service not connecting. This will be resolved at the Weather Server. Please be patient.

o Weather Forecast, Precipitation and Weather HI/LO temperature will not be displayed.

Note: If connection to app is lost: The last readings from the Internet will remain for up to 3 hours to allow

connection to reestablish on its own.

BACKLIGHT: DOES THIS STATION HAVE A BACKLIGHT?

Yes, your station has a backlight with 5 levels of intensity.

•

Press and release the LIGHT button to adjust the backlight intensity or to turn it off.

•

Intensity levels: 0% (OFF) | 1.5% | 20% | 50% | 100%

You can set your backlight to automatically dim to level 1 at a set hour for sleeping, then automatically return to full

brightness when you wake.

Set Auto Dim (Hour only):

1. Hold the LIGHT button 2 seconds to enter dimmer set mode. AUTO DIM OFF will show.

2. Press the + or – buttons to turn dimmer (ON). AUTO DIM ON will show.

3. Press the LIGHT button to select start time (Hour) for dimmer. AUTO DIM START TIME and the hour will flash.

4. Press the + or – buttons to change the hour for the dimmer to be low light level.

5. Press the LIGHT button to select start time for dimmer to be on High light level. AUTO DIM STOP TIME and the

hour will flash.

6. Press the + or – buttons to change the hour for the dimmer to be high light level.