Table of Contents
Advertisement
Malfunction
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:30 / -10" and/or
All other error codes.
Soap cooling
"E:30/-20"
Cause and Troubleshooting
Remove any unauthorized extensions from the
▶
water drain hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
Drain pump is clogged.
→
"Cleaning the drain pump", page 39
▶
Drain pump is clogged.
→ "Cleaning the drum", page 38
▶
if the fault is displayed again,
→
"Cleaning the drain pump", page 39
▶
Inlet opening of the rubber sleeve is clogged.
→ "Clean the inlet opening in the rubber sleeve",
▶
page 41
Strainer in the water supply is clogged.
▶ Clean the strainer in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
Malfunction
Please contact customer service.
▶
→
"Customer Service", page 52
To protect drain pipes, hot wash water is cooled
down before draining.
Wait for the soap to cool.
▶
Solenoid valve defective.
Please contact customer service.
▶
→
"Customer Service", page 52
Detergent dosage is too high.
Reduce the amount of detergent for the next wash
▶
with an equal load.
Additional water filled.
▶ Do not fill the device with additional water during
operation.
TroubleshootingNL
43
Advertisement
Table of Contents
