Table of Contents
Advertisement
CONTROLS AND CONNECTORS
A Power Switch / Power Indicator (POWER)
Green:
NOTE
Blue:
Orange: Power Management
B Input / Auto Button (INPUT / AUTO)
Input: Select either Analog or Digital for the signal input when both of the signal inputs are
connected to a signal source. Switch D-SUB and DVI-D whenever pressing the input button.
When only one of the two signal inputs is connected to the signal source, the one connected
NOTE
is automatically selected. Input Button is not available if there is no signal input from the
selected connector or during the power management mode.
Auto: Keep pressing the Input / Auto Button for 1-2 seconds.
See page 11 for Auto Set-up.
C Exit / Volume Button (EXIT /
D + / Brightness Button ( + /
E – / Contrast Button ( – /
F Menu Button (MENU)
G Headphone Connector
H Speakers
I AC Connector (AC IN)
J Audio Connector (LINE IN)
K DVI-D 24pin Connector (DVI-D)
L D-sub mini 15pin Connector (D-SUB)
M Keyhole for Security Lock
You can fasten a security lock and cable to prevent the monitor from being removed
NOTE
without your permission.
6
BEFORE YOU OPERATE THE MONITOR
PLE431S-e.p65
<Front>
Normal operation (ProLite E431S)
Normal operation (ProLite E431S-B / ProLite E431S-S)
The monitor enters into power management mode which reduces the power
consumption to less than 2W when receiving no horizontal and/or vertical
sync signal.
)
)
)
12
AC IN
LINE IN
DVI-D
D-SUB
<Back>
2004/08/06, 15:05
Advertisement
Table of Contents
