ROOMS TO GO A1361-18 Assembly Instruction Manual

ROOMS TO GO A1361-18 Assembly Instruction Manual

Dual power recliner with bluetooth speaker

Advertisement

Manufactured for Rooms To Go
NO.
Description
A
Backrest
B
Seat
Wall plug
C
transformer
Speaker wall
D
plug
transformer
ASSEMBLY INSTRUCTION
DUAL POWER RECLINER
WITH BLUETOOTH SPEAKER
HLVN A136 / A1360 / A1361

LIST OF PARTS

Item
Quantity
HLVN
A136-18
A1360-18
A1361-18
1
1
1
1
SKU:
15515604
11513606
11513618

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A1361-18 and is the answer not in the manual?

Questions and answers

Summary of Contents for ROOMS TO GO A1361-18

  • Page 1 ASSEMBLY INSTRUCTION DUAL POWER RECLINER WITH BLUETOOTH SPEAKER HLVN A136 / A1360 / A1361 Manufactured for Rooms To Go HLVN SKU: A136-18 15515604 A1360-18 11513606 A1361-18 11513618 LIST OF PARTS Description Item Quantity Backrest Seat Wall plug transformer Speaker wall...
  • Page 2 ASSEMBLY INSTRUCTIONS Step 1: Take out carefully the back cushions & seat from the packing. Step 2: Positing the female metal receiver brackets over the male metal posts. Push down the female brackets over male posts simultaneously until each side is locked into place an audile "click" is heard. POWER CONNECTION Step 3: Lift velcro flap located at the bottom back.
  • Page 3 Step 5: Bluetooth speaker power connection. With seat cushion facing down, connect female plug on chair and male plug on transformer. And connect transformer plug to electrical outlet. ELECTRICAL CONTROLS 1 Press button to recline the recliner to desired position 2 Press button to raise the recliner to the upright position.
  • Page 4 BLUETOOTH CONTROLS NOTE: Have your Bluetooth device (phone, tablet, mp3 player, etc.) turned on before starting. 1 Press the POWER button. Button will glow red. 2 Press and hold the POWER button. The other buttons will glow blue. The Power button will blink red. This indicates the system is searching for an available Bluetooth signal.
  • Page 5 WARNINGS * Keep unit at least 6" from wall. * Keep unit at least 24" from all heat sources. * Avoid placing unit in areas where unit can be exposed to direct sunlight other powerful light sources, as fading or discoloration may occur. * Do not reach under seat when mechanism is operating or serious injury may occur.
  • Page 6 CARE AND CLEANING * Upholstered furniture is packaged tightly to protect it during transsit. This packaging can sometimes cause creases or misshaped cushions when the furniture comes out of the packaging. These issues will correct themselves over time as the fibers of the cushions are exposed to air. However, shaping the cushions with your hands can alleviate the creases and compressed fibers more quickly.

This manual is also suitable for:

A1360-18A136-18155156041151360611513618

Table of Contents